marinco.com SHORE POWER 14 ELCI Inlets Marinco®'s solution to the ABYC E-11 requirement is based on our industry-standard marine inlets. We have taken the best available technology and built it into our inlets to provide boat builders and owners with the safest, best looking and most durable solution possible. All of our ELCI Inlets are ignition protected to comply with ABYC standards. We provide two modules in addition to the standard inlet. One houses the ELCI Marine Sensing Module, the other the breaker. Unlike competing systems, our ELCI Marine sensing module has a 3/4" diameter coil that accepts up to three 6-gauge conductors. This sensing module, which also incorporates a test circuit, is compatible with 30A 125V, 50A 125V and 50A 125/250V systems. There is a different breaker for 30A and 50A systems. LOAD LINE NO C ORANGE JUMPER SHUNT WHITE BLACK YELLOW (SHUNT) H N NORTH SHORE SAFETY PART # PGFM-111-B-A1-188 120V AC ELCI SENSING MODULE CURRENT CARRYING LEADS MUST BE TWISTED AS THEY PASS THROUGH THE COIL GROUNDING WIRE SENSATA 30 AMP ELCI BREAKER Single Phase 120V AC 30A (Hot, Neutral, Ground) LOAD LINE NO C ORANGE JUMPER SHUNT CURRENT CARRYING LEADS MUST BE TWISTED AS THEY PASS THROUGH THE COIL BLACK YELLOW (SHUNT) L1 (BLACK) L2 GROUNDING WIRE NORTH SHORE SAFETY PART # PGFM-111-B-A1-188 120V AC ELCI SENSING MODULE PANEL BOARD WHITE N SENSATA 50 AMP ELCI BREAKER Split Phase 120/240V AC 50A (Line 1, Line 2, Neutral, Ground) ELCI ABYC Standards Electrical current leakage is a serious safety concern for any boat connected to shore power. Because of this ABYC requirements now include specific measures for avoiding this danger. ABYC E-11.11.1 states “An Equipment Leakage Circuit Interrupter (ELCI) shall be installed with or in addition to the main shore power disconnect circuit breaker(s) or at the additional overcurrent protection as required by E-11.10.2.8.3 whichever is closer to the shore power connection.” TECH TIP Stainless Steel Housing for Sensing Modules • Cast 316 stainless steel OEM # 303SSRCDPL.OEM Standard Housing for Sensing Modules OEM # 301RCDPL.OEM Stainless Steel Housing for 30A or 50A Sensing Breakers • Cast 316 stainless steel OEM # 303SSBKRPL.OEM Standard Housing for 30A or 50A Sensing Breakers OEM # 301BKRPL.OEM Standard Sensing Breaker & Module Kits • Module & breaker packaged together 30A 120V AC Single Phase OEM # 301RCDKITIGN.OEM 50A 120/240V AC Split Phase OEM # 6353RCDKITIGN.OEM
RkJQdWJsaXNoZXIy MjgzMDI=